Collins Winged Emblem 516F-2 Power Supply in Very Good Condition with New Capacitors S/N 19415

This Collins Winged Emblem 516F-2 Power Supply in Very Good Condition with New Capacitors S/N 19415

 A Speaker has been installed in the cabinet and it was done nicely.

The Cabinet is in beautiful Condition with only a few very light marks.

 The original electrolytic capacitors have been replaced with new modern capacitors which is a must considering the age.

NOTE: This power supply is being held on reserve for anyone purchasing a Collins KWM-2 / 2A,  Transceiver or 32S-3 Transmitter from me. If you purchase a transmitter or transceiver from me and need this 516F-2, please contact me and I will allow it to be purchased.

I have tested the voltage both resting and under a simulated load on my custom test jig, and the voltages are correct and normal. This test data is included.

This 516F-2 has a metal Trim Ring which will not yellow like the ABS type trim rings.

 This unit has all the original Electrolytic capacitors which should be replaced before putting it into service as they are very old and could fail.

 This power supply will look great in any Collins station that is in excellent condition.

 The feet are new original Collins feet from the same company that made them for Collins and the Aluminum spun front risers are correct with a 3% cant on the bottom to place the feet flat on your desk.

It has been my experience that the chassis and cabinet must be shipped separately to prevent the cabinet from being damages. The shipping quote amount reflects this for two separate boxes.

 Because I am shipping separately, I have left the chassis out of the cabinet so you can see better pictures of both. Please be sure to look at all the pictures in this listing to get a good look at the cabinet and chassis!

I am selling this beautiful power supply as is, as described, for a client who spent years collecting vintage Collins and RL Drake Gear.

Description

The 516F-2 AC Power Supply provides all operating voltages for the Collins KWM-2/2A Transceivers and 32S- Transmitters. It operates from a 115 volts, 50- to 400-Hz power source to provide high-voltage dc, low-voltage dc, variable dc bias, and an ac filament supply. The provided voltages are connected to the associated equipment by a 60-inch cable, and are terminated in an 11-pin female cable connector that mates with a male power receptacle located on the Collins KWM-2/2A Transceivers and 32S-( ) Transmitters. As supplied, the 516F-2 is factory-wired for 115-volt operation.

516F-2 SPECIFICATIONS

     Dimensions ...................  7-3/4 in high,
                                     9-7/8 in wide,
                                     11-1/2 in deep.

     Weight .......................  30 Lb.

     Ambient temperature range ....  0 to + 50 ø C.

     Input requirements  ..........  115 volts, 50 to
                                     400 Hz, 4 or 2 amperes.
                                     (Remove capacitor C1 when
                                     using a line frequency
                                     higher than 60 Hz.)

     Output voltages

     Heater power .................  6.3 +0.3 volts ac.

     Low-voltage B+ ...............  275 volts dc. Transmit
                                     NLT 250 volts dc; receive
                                     NMT 310 volts dc

     High-voltage B+ ..............  800 volts dc. Transmit
                                     NLT 690 volts dc; receive
                                     NMT 970 volts dc.

     Bias voltage .................  -55 to -80 volts,
adjustable.