Ten-Tec
Ten-Tec 262 M, 20 Amp 13.8 VDC Deluxe Power Supply with Ammeter & VOX Option for the 540 & 544 Triton Series Transceivers and will work with Most Other Transceivers in Excellent Condition #1
- MPN:
- 262 M
- Condition:
- Used
- Shipping:
- $35.00 (Fixed Shipping Cost)
Description
This Ten-Tec 262 G, 20 Amp 13.8 VDC Deluxe Power Supply with Ammeter & VOX Option, is the matching power supply for the 540 & 544 Triton Series Transceivers, and will work with Most Other Transceivers.
It is in Excellent Condition and working.
This is one of the few Ten-Tec Power supplies that has a detatchable power cord which is included as well as the manual sheets.
This power supply is from a Ten-Tec Collector who is selling his Collection due to a planned move.
As with most of his gear, much of it has very few working hours of use.
I have tested this power supply with a Transceiver and it works fine with no problems.
I did not check the VOX operation
I am selling it as is as described, due to the age and weight, I will not accept returns.
Description
For use with Models 540 and 544. Fully voltage regulated to provide highly stable, pure DC (225 watts) from 117 VAC. Panel DC ammeter. Instantaneous overload protection circuit prevents damage caused by excessive current drain; reset by momentary turn-off. Includes a complete VOX system. VOX controls are located on front panel. Low frequency components invoice below cut-off frequency of speaker actuate T/R function.
Specifications
-
Input Voltage: 117 VAC, 50-60 Hz
-
Output Voltage: 13 VDC +/- 0.5 V
-
Regulation: Better than 1% no load to full load @ 117 VAC
-
Output Current: Zero to 18 A, with Ammeter
-
Ripple: Less than 60 mV p-p @ 18 A and 117 VAC
-
Circuit Breaker: Trips at 20 A (manual reset)
-
Output Connections: One 4-pin AMP MATE-N-LOK type. Two Phono Jacks for low current.
-
Finish: Satin aluminum front panel, black pebble-grain sides and top.
-
Semiconductors: 4 transistors, 1 SCR, 7 diodes
-
Size: HWD 4.5" x 8.25" x 13"
-
Weight: 15 lbs
VOX Specifications
-
Mic Input Impedance: Greater than 3 megohms for crystal, ceramic, or hi-Z dynamic microphones
-
Transmitter Microphone Channel Gain: Unity
-
Maximum Microphone Input Level: 250 mV, rms
-
VOX Sensitivity: Less than 1 mV @ 200 Hz trips T/R
-
Delay: Adjustable from 0.1 to 1 sec.
-
Semiconductors: 1 IC, 10 transistors, 3 diodes
Related Products
Ten-Tec 262 M, 20 Amp 13.8 VDC Deluxe Power Supply with Ammeter & VOX Option for the 540 & 544 Triton Series Transceivers and will work with Most Other Transceivers in Excellent Condition #2
Ten-Tec
Ten-Tec 262, 20 Amp 13.8 VDC Deluxe Power Supply / Speaker with VOX Option for the 540 & 544 Triton Series Transceivers and will work with Most Other Transceivers in Excellent Condition
Ten-Tec
Ten-Tec 262 G, 20 Amp 13.8 VDC Deluxe Power Supply / Speaker with VOX Option for the 540 & 544 Triton Series Transceivers and will work with Most Other Transceivers in Excellent Condition #1
Ten-Tec
Ten-Tec 252 M, 20 Amp 13.8 VDC Power Supply with Ammeter for the 540 & 544 Triton Series Transceivers and will work with Most Other Transceivers in Excellent Condition #1
Ten-Tec
Ten-Tec 261, 10 Amp 13.8 VDC Deluxe Power Supply / Speaker with VOX Option for the 540 Triton I Transceiver and will work with Most Other Transceivers in Good Condition
Ten-Tec