Featuring Fine Vintage and Modern Amateur Radio Gear For Sale

Ten-Tec 280, 20 Amp 13.8 VDC Power Supply for the Delta & Corsair and will work with Most Other Transceivers in Excellent Condition S/N 280 02115

Write a Review
MPN:
280
Condition:
Used
Shipping:
$45.00 (Fixed Shipping Cost)
  • Ten-Tec 280, 20 Amp 13.8 VDC Power Supply for the Delta & Corsair and will work with Most Other Transceivers in Excellent Condition S/N 280 02115
  • Ten-Tec 280, 20 Amp 13.8 VDC Power Supply for the Delta & Corsair and will work with Most Other Transceivers in Excellent Condition S/N 280 02115
  • Ten-Tec 280, 20 Amp 13.8 VDC Power Supply for the Delta & Corsair and will work with Most Other Transceivers in Excellent Condition S/N 280 02115
  • Ten-Tec 280, 20 Amp 13.8 VDC Power Supply for the Delta & Corsair and will work with Most Other Transceivers in Excellent Condition S/N 280 02115
  • Ten-Tec 280, 20 Amp 13.8 VDC Power Supply for the Delta & Corsair and will work with Most Other Transceivers in Excellent Condition S/N 280 02115
  • Ten-Tec 280, 20 Amp 13.8 VDC Power Supply for the Delta & Corsair and will work with Most Other Transceivers in Excellent Condition S/N 280 02115
  • Ten-Tec 280, 20 Amp 13.8 VDC Power Supply for the Delta & Corsair and will work with Most Other Transceivers in Excellent Condition S/N 280 02115
  • Ten-Tec 280, 20 Amp 13.8 VDC Power Supply for the Delta & Corsair and will work with Most Other Transceivers in Excellent Condition S/N 280 02115
$99.99
Frequently bought together:

Description

This Ten-Tec 280, 20 Amp 13.8 VDC Power Supply for the Delta & Corsair and will work with Most Other Transceivers in Excellent Condition S/N 280 02115

 

 This power supply is from a Ten-Tec Collector who is selling his Collection due to a planned move. 

As with most of his gear, much of it has very few working hours of use.

 I have tested this power supply with a Transceiver and it works fine with no problems.

Description

Ideal for powering the Delta 580 and CORSAIR Model 560 transceiver on either 115 or 230 VAC, 50-60 Hz. Easy to change for either primary voltage. Regulated output, over-voltage and over-current protected, and can be switched from transceiver or power supply. Same circuitry as the Model 255, but with dual primary and without the build-in speaker.

Specifications

  • Input Voltage: 105 - 125 VAC, 50-60 Hz or 210 - 250 VAC, 50-60 Hz
  • Output: 13.5 VDC +/- 0.5 VDC.
  • Regulation: Better than 1% no load to full load at 117 VAC.
  • Output Current: 18 amperes, full load; 20 amperes, maximum.
  • Ripple: Less than 60 mV peak-to-peak at 18A at 117 VAC.
  • Circuit Breaker: Electronic latching. Factory set at 20A.
  • Over-Voltage Protection: Trips above 16V output.
  • Panel Meter: 0 - 25 amperes.
  • Connections: Attached 3' cable with four pin AMP MATE-N-LOC connector for high current and remote on/off switching. Two phono connectors for low current output.
  • Finish: Dark painted front panel, dark textured top and sides.
  • Size: HWD 5.5" x 7" x 12".
  • Wt: 15 lbs.
View AllClose

Related Products