Ten-Tec
Ten-Tec Power Mite PM-1 QRP Transceiver in Excellent Cosmetic Condition
- MPN:
- PM-1
- Condition:
- Used
- Shipping:
- $22.00 (Fixed Shipping Cost)
Frequently bought together:
Description
This Ten-Tec Power Mite PM-1 QRP Transceiver is in Excellent Cosmetic Condition
I tested this Beatiful Radio on the air and it has noise in the speaker phone output but does not receive or transmit, so it will need some attention.
It comes with a power cord.
Please check my other listings for accessories for this radio as I have a few listed.
-
Description
The MX1, AA1, VO1, and TX1 modules are wired into a band-switching 80-40 meter CW transceiver. Front panel controls: On-off, Transmit-Receive, Receiver Resonate, VFO-Crystal, Bandswitches, Oscillator tuning, Final Resonate. A meter is provided to monitor final amplifier current.
-
40-80 meters. 15 meter converter available.
-
Crystal control or transceive operation (Transceive on 40-80 meters, crystal only on 15 meters.)
-
Slide-rule dial. Flywheel tuning.
-
Power - 12 volt lantern battery.
-
Front panel band switching.
-
Shaped audio - 200-2500 Hz.
-
Metered power amplifier stage.
-
Silicon transistors. Integrated circuit.
-
2 KHz receiving band width
-
2 watts input to final stage
-
100 cycles drift. No warm-up.
Accessories
-
Keying Monitor Model AC2
-
15 Meter Converter Model AC3
-
Low Power SWR Meter Model AC4
-
Low Power Antenna Tuner Model AC5
Specifications
-
Frequency Range: 3.475 - 4.025, 6.975 - 7.325
-
Size: HWD 4" x 10.125: x 7.5"
-
Shipping Weight: 4 lbs
-
Power: 12 volts. 20 ma on receive, 300 ma on transmit
-
Semiconductor devices: 1 dual gate MOSFET, 1 integrated circuit, 4 silicon transistors
-
Type of Reception: CW - SSB - AM
-
Sensitivity: Less than one microvolt provides readable signal
-
Antenna input: 50 - 75 ohms
-
Selectivity: 2 KC at 6 dB down points
-
Audio:Output impedance - 1000 ohms. Frequency response - +/- 3 dB 200 Hz - 2500 Hz
-
Frequency stability: Less than 100 Hz drift
-
Transmitter: Power - 2 watts input. Output impedance 50 - 75 ohms, fixed link
-
Headphones: Front panel tip jacks are provided
-
Key: Phono jack is provided on rear apron
-
Crystal: A crystal socket is provided on the front panel. The socket accepts holders of the HC6U type or any crystal with 0.486 inch spacing and 0.050 diameter pins.
-