Ten-Tec
Ten-Tec Power Mite PM-2B QRP Transceiver in Like New Cosmetic Condition in Original Box
- MPN:
- PM-2B
- Condition:
- Used
- Shipping:
- $25.00 (Fixed Shipping Cost)
Description
This Ten-Tec Power Mite PM-2B QRP Transceiver is in Like New Cosmetic Condition in the Original Box.
I tested this Beatiful Radio on the air and it has noise in the speaker phone output but does not receive or transmit, so it will need some attention.
It comes with a copy of the manual and a power cord.
Please check my other listings for accessories for this radio as I have a few listed.
Description
The Power-Mite 2B is the same as the Power-Mite 2 Version 2 with the addition of VFO control on 20 meters and sidetone. The Power-Mite 2B has one large circut board with VFO transmit and receive on 80, 40, and 20 meters. No optional boards were available.
Front panel controls: On-off, Transmit-Receive, Receiver Resonate, VFO-Crystal, Bandswitches, Oscillator tuning, Final Resonate. A meter is provided to monitor final amplifier current.
-
40-80-20 meters.
-
Crystal control or transceive operation (Transceive on 40-80-20 meters, crystal only on 15 meters.)
-
Slide-rule dial. Flywheel tuning.
-
Power - 12 volt lantern battery.
-
Front panel band switching.
-
Shaped audio - 200-2500 Hz.
-
Metered power amplifier stage.
-
Silicon transistors. Integrated circuit.
-
2 KHz receiving band width
-
2 watts input to final stage
-
100 cycles drift. No warm-up.
Accessories
Specifications
-
Frequency Range: 3.475 - 4.025, 6.975 - 7.325
-
Size: HWD 4" x 10.125: x 7.5"
-
Shipping Weight: 4 lbs
-
Power: 12 volts. 20 ma on receive, 300 ma on transmit
-
Semiconductor devices: 1 dual gate MOSFET, 1 integrated circuit, 4 silicon transistors
-
Type of Reception: CW - SSB - AM
-
Sensitivity: Less than one microvolt provides readable signal
-
Antenna input: 50 - 75 ohms
-
Selectivity: 2 KC at 6 dB down points
-
Audio:Output impedance - 1000 ohms. Frequency response - +/- 3 dB 200 Hz - 2500 Hz
-
Frequency stability: Less than 100 Hz drift
-
Transmitter: Power - 2 watts input. Output impedance 50 - 75 ohms, fixed link
-
Headphones: Front panel tip jacks are provided
-
Key: Phono jack is provided on rear apron
-
Crystal: A crystal socket is provided on the front panel. The socket accepts holders of the HC6U type or any crystal with 0.486 inch spacing and 0.050 diameter pins.
Related Products
Ten-Tec Power Mite PM-2B QRP Transceiver in Excellent Cosmetic Condition
Ten-Tec
Ten-Tec Power Mite PM-2 QRP Transceiver in Excellent Cosmetic Condition in the Original Box
Ten-Tec
Ten-Tec Argonaut Model 509 QRP 5 Watt Transceiver in Excellent Condition
Ten-Tec