Collins S-Line Feet Set with Aluminum Tapered Extenders

This Collins S-Line Full Set of ORIGINAL Collins Feet, with Aluminum Tapered Extenders and 18-8 Stainless Steel Hardware, is required for each radio or accessory in your station and will tilt your gear back, making them easy to see and operate!

The (4) rubber feet in this set are THE Original Collins feet with the proper Collins part number as shown in the manual. The (2) very hard to find Aluminum Tapered Risers are Milled to factory specifications, and have a satin black powder coat finish.

The finish is semi gloss powder coat.

They are tapered top to bottom and front to back with a 3 degree cant, so your radio will sit flush and flat on the front feet.

They are not cheap, foreign made, plastic imitations.

The Hardware included with this set of feet, is 18-8 stainless steel and not cheaper zinc plated steel.

Stainless hardware was originally supplied with Collins Radios because regular steel hardware will strip easy and will rust.

Do not be fooled by other listings with cheap hardware and fake extenders! The quality of this set is equal to the quality of fine Collins Radios!

They come with a full money back satisfaction guarantee! I also have just the Tapered extenders with the 2 long screws offered in another listing if you only need the extenders and I have just the rubber feet listed as well if you only need to replace them!

They are THE Collins feet used for decades on the S-Line and KWM-2 Radios and accessories, and are of the highest quality, with the washer embedded in them.

The rubber feet measure 0.469 high, 0.312 countersink diameter, 0.219 0 countersink depth, .172 inner diameter, and a 0.719 outer diameter.

Most of the original Feet on the S-Line and KWM-2 gear have been replaced through the years with various types of feet. Some with a taper some without, and many different sizes and rubber type.

These feet are the perfect rubber compound for Collins radio gear. They are not too soft as to leave rubber skid marks when you slide your radio across the table, yet they have sufficient grip and are rigid enough to hold under the weight of a Collins 30L-1 Amplifier.You can be assured these are original and the proper size as per Collins and Rockwell Collins Specifications.