Accessories

This Collins 51S-1 Weighted PTO Knob Insert, is custom made for 51S-1 the PTO Knobs with Finger Hole. This Weighted insert is designed for Collins Spinner PTO knobs (with Finger Hole)  Looking at the back of your PTO knob, and the bump from the...

This Collins 51S-1 Receiver WHITE Bartlett Meter face, is a very high quality reproduction designed to Replace the Amber color meter face that most 51S-1 receivers were made with.    This High Quality reproduction (Made in the...

Collins Antenna Coupler Type 179J-17 P/N 622-1786-002 New

This set of Collins KWM-2 /A  PM-2 Mounting Thumb Screws and Chassis Bushings, is a very high quality reproduction of the original set, which is required to mount the PM-2 "Piggy Back" power supply on the back of the KWM-2 and KWM-2A.  This set...

This Collins KWM-2 / 2A & 32S-3 Loading Control Lever, is in Excellent Condition.  This fits both the KWM-2 and 32S-3.  This is one of the harder parts to find as they do break.  I have only a few left so it may be prudent to pick up a...

This Collins KWM-2A, 75S-3C, & 32S-3A Band Selector Card Reproduction, will replace your marked up band selector card in the a fore mentioned radios,  This reproduction is a bit thinner than the original and looks great.   They do not...

This Listing is for one (1) ORIGINAL Leviton Lumiline # 476 End Cap, which are required to hold the Lumiline bulb on the Collins 312A-1 Speaker and 312A-2 Console. They are also found in Vintage AM/FM Transmitters display cabinets, jukebox, or other...

This Listing is for one (1) Basic set of Premium interconnect cables for the Collins S-Line. They are custom made and professionally constructed in a Commercial Electronics Lab. This is a high quality set of Cables Consisting of three BELDEN RG58/U...

NOTE:  I will require a Cashiers Bank check or Wire transfer for this item. You can purchase it and select Check/ Money Order for payment and this will reserve it.   This Collins RARE 312-2 Station Console for the 75A-4 & KWS-1,...

This Collins Second Crystal Deck Cover Plate for 75S-3C, 32S-3A, & KWM-2A, is in excellent condition with Felt on the side that presses on the installed crystals in the bottom deck.

This Collins SM-3 Switch Kit with Original Face Plate, PTT Switch, Bezel Nut, & PTT Switch Button Nipple, is everything you need to refurbish an SM-3 Microphone that has had the switch changed or the switch face plate replaced or damaged.  The...

This General Electric 6BF5 Audio Tube Sleeve of 5, are brand new tubes. this is the audio tube that has a lot of gain and is used in the Collins S-Line receivers.  It tends to run hot because of the high gain so it is nice to have some spares. I...